|
|
This is a discussion on Removing stem from 929 lower triple within the Tools / Garage / Paddock forums, part of the General Utility Vehicle Discussion category; I'm working on a project bike and need to pull the stem out of a 929 lower triple and replace it with a 919 stem. ...
|
|||||||
| Tools / Garage / Paddock Discussion of Motorcycle Related Tools, Stands, Lifts, etc. |
 |
|
|
LinkBack | Thread Tools |
12-08-2008, 5:00 PM
|
|||
|
|||
|
Removing stem from 929 lower triple
I'm working on a project bike and need to pull the stem out of a 929 lower triple and replace it with a 919 stem.
The 919 stem pressed out of the 919 lower triple without issue, but the 929 stem won't budge. We tried heating the bottom of the stem/triple area with a torch and were using a 12-ton press, but no luck. Is there a trick to getting the 929 stem out of the triple?? Thanks, Mike 
|
|
12-09-2008, 12:11 AM
|
||||
|
||||
|
Re: Removing stem from 929 lower triple
i wish i could tell you. . . try the streetfighter section peeps, cuz front end swaps are common amongst fighters
__________________
I Ride a Custom Fighter!
|
|
Lower Navigation
|
||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Search tags for this page |
honda 929 steering stem nut,how to remove a stem from a triple,how to remove lower triple,kx pressing out steering stem,pressing out a steering stem
Click on a term to search our sites for related topics.
|
| Thread Tools | |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| question on pin spanner wrench or steering stem nut sockets... | SomeStrangeGuy | Tools / Garage / Paddock | 6 | 06-16-2006 12:21 PM |
