|
|
This is a discussion on Front Brakes Master Cylinder within the Tools / Garage / Paddock forums, part of the General Utility Vehicle Discussion category; I purchased all new stainless brake lines and a whole new modern aftermarket master cylinder brake assembly. Installed and bled the system throughly but still ...
|
|||||||
| Tools / Garage / Paddock Discussion of Motorcycle Related Tools, Stands, Lifts, etc. |
 |
|
|
LinkBack | Thread Tools |
06-14-2008, 10:44 AM
|
|||
|
|||
|
Front Brakes Master Cylinder
I purchased all new stainless brake lines and a whole new modern aftermarket master cylinder brake assembly. Installed and bled the system throughly but still no brakes! During the bleeding process I was unable to build pressure buy pumping the brake with the caliper nipple valve closed. The piston in the master cylinder could be cavetating...but it's brand new!
 The manual says to put a small block behind the brake lever when bleeding. I didn't do this, could that be the prob???? If so, what is the easiest way to fix. I need to get this fixed so I can get back on the saddle and cruise! 
|
|
06-14-2008, 10:59 AM
|
||||
|
||||
|
Re: Front Brakes Master Cylinder
If the new lines are filled and you're using the correct bleeding procedure, than I would suspect the aftermarket M/C.
|
|
Lower Navigation
|
||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Search tags for this page |
honda big red front brakes
Click on a term to search our sites for related topics.
|
| Thread Tools | |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1995 CR125R Cylinder issue | andrewjoseph | Honda ATV Discussions | 4 | 05-29-2008 5:21 AM |
