Exhaust servo motor

#1 (**permalink**) 07-04-2007, 12:10 AM

My exhaust servo motor is out again (second one). Is there a way to bypass the exhaust valve so I can continue to ride untill my new servo motor arrives?

#2 (**permalink**) 07-04-2007, 5:37 AM

Yes, physically turn the servo to the fully open position and unplug it. Then get yourself a full micron exhaust system and pcIII. And never worry about it again.

#3 (**permalink**) 07-04-2007, 9:52 AM

Thanks for the reply. Already have a pcIII. I did see a eliminator kit made by Hass Motorsports that would be cheaper than a full system.

#4 (**permalink**) 08-12-2007, 9:33 PM

Which way to turn to get the servo motor fully open?

#5 (**permalink**) 11-03-2007, 10:11 AM

turn the valve so that it locks when its at the top of its travel however it will turn again its self with vibration restricting your air flow so make a little bracket to lock it in place

#6 (**permalink**) 03-21-2008, 5:09 PM

can just take the flapper out of the exhaust all together and throw a bolt in there to cover up the hole, load a proper map.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Motor swap help	gsxrjohn	Tools / Garage / Paddock	0	08-03-2008 10:07 PM

Exhaust servo motor

exhaust sistems with servomotor

what is an Exhaust Servo Motor

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)