Made myself a rear stand....

KXCAM,
I finally got to the garage where i keep my stuff at and I calculated the degree from the arm today and the pit bull is 60 degrees. I will have to take some pics tomorrow. My stand is in my garage at another house so i'll be there tomorrow with my camera and take some picures....

Thanks again guys for the compliments....

Hey strike, if you want you could checkout some of my fox pics on my home page.... I have my turbo installation up. I have to add to it but there is picutes....
Turbo Installation

Excellent work! Also checked out the rest of the site too. I envy you. I'd love to do as much hands-on stuff as you have but don't have the time and resources to do it yet.

You got plans for it? like measurements?

Originally Posted by schm

You got plans for it? like measurements?

nah... Just measured and fabricated as I went along. The most important measurement is the distance between the 2 pipes where the adjustable sliders are that the swing arm rests on. I have a distance of 14-1/16". Its easy to build. If you have any questions just post it up.

i need this one http://www.mustangous.com/motorcycle...C01501_med.jpg

That's nice.Nice work.

Originally Posted by Mustangous

I would like to research powder coating for things like this....

i would realy like to learn to weld and have been looking into some decent outfits but the cost is a little out of reach right now. as far as the powdercoating ive been doing that for 3yrs now in my garage and have built my own oven and holding fixtures. its great stuff and the results are awesome once you get the prep and application skills down. im also with you on the 929/954 engine swap i did it along with the swing arm swap. very nice looking welds i hope i can achieve some results like those in the future.