|
|
This is a discussion on Need help with speed sensor.... within the Electronics forums, part of the General Utility Vehicle Discussion category; Hi. I just bought an Acewell 3701-mx digital gauge. The sensor they sent me has a magnet bolt and a sensor. My bike is a ...
|
|||||||
| Electronics Discussion of Motorcycle Related GPS, Audio, Video, Radar Detectors, Lap Timers, Communicators, etc. |
 |
|
|
LinkBack | Thread Tools |
07-12-2007, 10:42 PM
|
|||
|
|||
|
Need help with speed sensor....
Hi. I just bought an Acewell 3701-mx digital gauge. The sensor they sent me has a magnet bolt and a sensor. My bike is a 95 Honda cbr 600 f3. I've look at the schematic on my bike and it has three wires. The sensor that came with the gauge has only two wires. I don't know much about this stuff so if any of you can help, I would greatly appreciate it.
|
|
07-18-2007, 3:05 AM
|
|||
|
|||
|
Re: Need help with speed sensor....
Aren't you supposed to run the sensor down your fork leg and then bolt the magnet onto your disk? I'm not sure the unit supports a signal from your existing speedo sensor. I would think that a 95 CBR might even have a cable driven speedo.
|
|
Lower Navigation
|
||||||
|
||||||
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Search tags for this page |
big red speed sensor,honda big red cpk sensor,where is the speed sensor on honda big red
Click on a term to search our sites for related topics.
|
| Thread Tools | |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bank angle sensor | tom fritz | Tools / Garage / Paddock | 4 | 11-17-2008 2:03 AM |
| O2 Sensor plug on '03 954? | jaim | Tools / Garage / Paddock | 5 | 12-31-2007 12:19 AM |
| Gear Position sensor | djwimbo | Electronics | 11 | 11-04-2007 2:36 AM |
